|
|
Screen Printing & Dyeing Equipment |
|
|
Manual Printing Tables |
 |
| For Garments "Piece" Printing Application |
The “Manual” Type Printing Tables, comprise of the following:-
| • |
A Galvanized Steel Base-frame structure retaining Leg height adjusters and Floor Steel containments for ensuring Linear Expansion of the Table Structure. |
| • |
A reinforced Laminated Chip Board Table Surface, covered with 2 layers of 4 mm. thick Polyester Under-Felt. |
|
|
|
| • |
Table Print Surface comprising of a ~Contex~ PVC coated Single Ply Polyester Print Blanket. |
| • |
Printing Table, equipped with Printing Screens Locating/Support Rails inclusive of relative Repeat Blocks and Drainage side channels, |
|
| |
Electrical Heated Under-blanket System
With the increase in the demand for Garments to be Printed with Plastisols and Rubber Print Pastes, an Electrical Heated Underblanket System is offered as Optional Extra for maintaining the Print Table Surface heated up to 65 Deg Cent., comprising of a special Wire Mesh for enclosing between the 2 Layers of Under-felt, complete with Auto-Transformer for Setting the desired Temperature.
The advantages of using the K+Z Printing Tables are due to the following : |
| |
| • |
Higher Print Definition obtainable from the K+Z (Soft Surface) Printing Tables. |
| • |
Production reliability as opposed to the Pallet Printers. |
| • |
The ability to use Heated Under-blanket facility and Infra-red Heated Traveling Carriages for Drying the Printed Fabrics. |
|
|
| Average Production from a K+Z 40 Mts Long Manual Type Printing Table are as follows: |
| • |
Single (1) Colour : 1,300 Cut Pieces/Hour |
| • |
Two (2) Colours : 950 Cut Pieces/Hour |
| • |
Three (3) Colours : 600 Cut Pieces/Hour |
| • |
Four (4) Colours : 350 Cut Pieces/Hour |
|
| |
|
